TMS zl Management and Configuration Guide ST.1.1.100430

2-83
Initial Setup in Routing Mode
Configure Event Logging
Figure 2-48. Add SNMPv2 Destination Window
2. For Server Address, type the IP address or FQDN of the SNMP server. For
example, if you are using PCM+, you would enter the IP address or FQDN
of the server running PCM+.
3. For Community Name, type the read-write (unrestricted) community name.
You must enter the read-write community name that is configured on the
SNMP server.
4. Click OK.
5. Click Save.
If you want to add more SNMP v2 trap receivers, repeat these steps. Use the
Edit and Delete icons in the Tools column to modify or remove a trap receiver.
Add an SNMPv3 Trap Destination
To add an SNMPv3 trap destination (such as PCM+), complete the following
steps:
1. Under Enable SNMPv3 traps, click Add another destination. The Add SNMPv3
Destination window is displayed.