TMS zl Management and Configuration Guide ST.1.1.100430

3-25

Initial Setup in Monitor Mode

Configure Initial Settings

Before you can access the Web browser interface and begin configuring the

TMS zl Module, you must configure some initial settings. Specifically, you must

access the CLI and complete these tasks:

■ Set the operating mode to monitor.

■ Specify a management VLAN. (The default is VLAN 1.)

■ Set a static IP address for the VLAN.

■ Set a default gateway for the module.

To configure these settings, follow these steps:

1. You should be at the manager context of the TMS zl Module Product OS.

(See “Access the TMS zl Module Product OS Context” on page 3-22.)

2. Enter the configuration context for the module:

hostswitch(tms-module-C)# configure terminal

3. Set the operating mode to monitor:

You will be prompted to confirm that you want to change operating modes

and asked if you want to save the current configuration.

hostswitch(tms-module-C:config)# operating-mode

monitor

Changing the operating mode requires a reboot to take

effect. Do you want to continue [y/n]? y

Do you want to save the current configuration [y/n]? y

4. Configure the management VLAN:

Syntax: configure terminal

Enters the configuration context for the module.

Syntax: operating-mode monitor

Enters the configuration context for the module.

Syntax: management vlan <VLAN ID>

Sets the VLAN for management and HA traffic.