TMS zl Management and Configuration Guide ST.1.1.100430

3-38
Initial Setup in Monitor Mode
Management Settings
b. For IP Address and Subnet Mask, type the management IP address and
subnet mask.
3. Click Apply My Changes.
4. Click Save.
Change the Management Users’ Passwords
To protect your network, HP strongly recommends that you immediately
change the passwords for the manager and operator accounts.
Note Complete this task even if you plan to use RADIUS authentication for admin-
istrators because the local accounts remain active whether RADIUS authen-
tication is enabled or not.
To configure new passwords for local management users, follow these steps:
1. Click Network > Authentication and click the Management Users tab.
Figure 3-18. Network > Authentication > Management Users Window
2. From the User list, select manager (read/write) or operator (read only).
3. For Old password, type the current password.