TMS zl Management and Configuration Guide ST.1.1.100430

3-43
Initial Setup in Monitor Mode
Default Gateway and Static Routes
Table 3-8. RADIUS Attributes Sent in Management Access RADIUS Request
Default Gateway and Static Routes
This section explains how to:
■ Modify the existing default gateway or add a second default gateway
■ Add static routes
Change the Default Gateway
Typically, you should configure the default gateway as part of the initial set up
from the CLI; however, you can also configure the default gateway from the
Web browser interface. You can also add a second default gateway. In this
case, the metric and administrative distance for the two default routes will
determine which is preferred.
To set the default gateway, follow these steps:
1. Select Network > Routing > Static Routes.
2. Click Add static route.
Attribute Value
Username Username submitted in the log in window
Password Password submitted in the log in window
Calling-Station-ID User’s IP address
NAS-Identifier NAS Identifier configured for the module when
you specified the RADIUS server
NAS-IP-Address Module IP address on the TMS VLAN that
connects to the RADIUS server
Service-Type NAS-Prompt-User