TMS zl Management and Configuration Guide ST.1.1.100430

3-45
Initial Setup in Monitor Mode
Default Gateway and Static Routes
Create a Static Route
Typically, the TMS zl Module’s default gateway can perform all the routing that
the module requires in monitor mode. However, if you need, you can create a
static route to a specific network or host through a different gateway. Follow
these steps:
1. Access the Network > Routing > Static Routes window.
2. Click Add Static Route. The Add Static Route window is displayed.
Figure 3-23. Add Static Route Window
3. For Destination Type, select the destination type: Network or Host.
4. The Destination Address depends on the destination type that you chose:
• Network—type the IP address and subnet mask of the destination.
• Host—type the IP address of the host.
5. For Gateway Address, type IP address of the next-hop router.
6. For Metric, type a value to represent the distance to the destination
address. Typically, the metric for a static route is 0.
7. For Distance, type the administrative distance. Typically, the distance for
a static route is 1.
8. Click OK. The route is now displayed in the Network > Routing > Static Routes
window.