TMS zl Management and Configuration Guide ST.1.1.100430

3-46

Initial Setup in Monitor Mode

Change the Operating Mode

If you would like to change the operating mode, you can do it from the Web

browser interface by completing the following steps. Remember, however,

that the module will be rebooted and the last saved startup configuration from

that mode will be loaded.

1. Select System > Settings and click the Operating Mode tab.

Figure 3-24. System > Settings > Operating Mode Window

2. Select Routing or Monitor. See “Operating Modes” in Chapter 1: “Overview”

for an explanation of the operating modes.

3. Click Apply My Changes.

4. A warning box is displayed, informing you that you must reboot the TMS

zl Module to apply the change:

•Click Save & reboot to save your configuration changes and reboot the

TMS zl Module.

•Click Reboot without saving to reboot the TMS zl Module without

saving any changes that have not yet been saved.

Whichever choice you make, the TMS zl Module reboots in the new operating

mode with the last configuration made for that operating mode. If the module

has not been configured in this operating mode before, it is booted at the

factory default settings. To learn how to set up the module for management

access in the new mode, see:

■ “Initial Setup” on page 2-16 of Chapter 2: “Initial Setup in Routing

Mode”for routing mode

■ “Initial Setup” on page 3-9 for monitor mode