TMS zl Management and Configuration Guide ST.1.1.100430

3-66
Initial Setup in Monitor Mode
System Maintenance
Figure 3-41. System > Maintenance > Back Up/Restore Window
2. Click Back Up and follow the prompts to save the startup configuration
file to a selected directory. If possible, it is best to name the configuration
file after the date on which it was saved. For example, if the configuration
was saved on November 03, 2009, name it 2009-11-03.cfg.
Note The saved configuration file is encrypted. If you need to analyze the saved
configuration, contact HP ProCurve technical support.
Restore to a Previously Saved Configuration
To restore the module to a previously saved configuration file, follow these
steps:
1. Make sure that the configuration file is saved to a drive on the manage-
ment station.
2. In the TMS zl Module Web browser interface, click System > Maintenance.
Click the Back Up/Restore window.
3. Click Browse.
4. Navigate to the saved configuration file and double-click the file to
select it.
5. Click Restore and Reboot.
6. A warning window is displayed. Click Yes to continue.
The module copies the configuration that you selected in step 4 to the startup-
config. It then reboots and loads the configuration.