TMS zl Management and Configuration Guide ST.1.1.100430

5-33
Network Address Translation
NAT Examples
Note In this example, you could also select Any Address because VLAN 10 is the
only VLAN in the zone.
h. From Destination, select VLAN20.
i. For NAT IP address, select Use IP of routed VLAN interface.
The TMS zl Module will translate the traffic to 10.1.2.107, which is the
TMS zl Module’s IP address on VLAN 20, the VLAN on which the traffic
will be forwarded.
Figure 5-17. Add NAT Policy Window
j. Click OK.
k. Click Save.
4. Create a firewall access policy to allow the NAT traffic.
a. Click Firewall > Access Policies > Unicast.
b. Click Add a Policy. The Basic tab is displayed.
c. For Action, select Permit Traffic.
d. For From, select INTERNAL.
e. For To, select DMZ.