TMS zl Management and Configuration Guide ST.1.1.100430

6-25
Intrusion Detection and Prevention
Configure IDS/IPS
The host switch assigns index numbers based on:
■ The number of TMS zl Modules and HP ProCurve ONE Services zl Module
that are installed in the host switch
■ The order in which each product boots on the host switch
Keep in mind that each time the host switch boots, the products could
potentially boot in a different order, and the index numbers assigned to each
product would change. (For more information, see “Chapter 2: Initial Setup
for Routing Mode” or “Chapter 3: Initial Setup for Monitor Mode.”)
To view the slot ID or product index for a particular module, enter:
hostswitch# show services
2. Display the TMS-subscription hardware ID by typing the following com-
mand:
3. Record the TMS-subscription hardware ID. (You may want to copy this
hardware ID to a text file.) You will use the TMS-subscription hardware
ID to register the IDS/IPS signature subscription.
If you would prefer to obtain the TMS-subscription hardware ID from the Web
browser interface, complete the following steps:
1. Access the TMS zl Module’s Web browser interface, and click Intrusion
Prevention/Detection > Signatures > Download.
2. The TMS-subscription hardware ID is shown under IPDS Subscription
Hardware ID at the bottom of the window. (You may want to copy this
hardware ID to a text file.) You will use the TMS-subscription hardware
ID to register the IDS/IPS signature subscription.
Syntax: show ips
Displays the IPS information, including the TMS-sub-
scription hardware ID.