TMS zl Management and Configuration Guide ST.1.1.100430

6-33
Intrusion Detection and Prevention
Configure IDS/IPS
• Protection—Select one of the following:
– Server to view only the signatures that detect attacks targeting
servers
– Client to view only the signatures that detect attacks targeting
clients
– Client & Server to view only the signatures that detect attacks
targeting both servers and clients
– Any to view all three types of signatures—those that detect
attacks targeting servers, those that detect attacks targeting cli-
ents, and those that detect attacks targeting both clients and
servers
Figure 6-12 shows the differences among these filters:
Figure 6-12. Filters for Viewing Signatures Based on the Protection They Provide
• Threat Level—Select Any to view all signatures, no matter what threat
level they have, or select one of the following to view signatures with
a specific threat level: Critical, Severe, Minor, Warning, or Information.
For example, you might set the Status filter to All, the Protection filter to
Servers, and the Threat Level filter to Critical. You would then view all
signatures that meet these criteria:
• Detect attacks that target servers
• Have a threat level of Critical