TMS zl Management and Configuration Guide ST.1.1.100430

7-206
Virtual Private Networks
Configure a GRE Tunnel
f. For Destination, specify the actual IP address of the remote tunnel
endpoint.
This is the Destination IP Address that you specified in the GRE tunnel.
It is different from the address configured on the subnet reserved for
the tunnel.
g. Click Apply.
5. Permit local traffic that is sent across the tunnel (before it is encapsulated
by GRE):
a. For Action, leave the default, Permit Traffic.
b. For From, select the local zone.
c. For To, select the tunnel zone.
d. For Service, leave Any Service.
This is the most basic configuration. You could also create access
policies that allow only certain types of traffic.
e. For Source, specify the local IP addresses that are allowed to send
traffic on the tunnel.
f. For Destination, specify the IP addresses behind the remote tunnel
endpoint to which the local endpoints are allowed to send traffic.
Figure 7-169. Add Policy Window