TMS zl Management and Configuration Guide ST.1.1.100430

7-218
Virtual Private Networks
Configure a GRE over IPsec VPN with IKE
7. For Distance, type the administrative distance.
Typically, the distance for a static route is 1. However, if this is a route
over a backup GRE tunnel, type a higher value than that for the primary
route. For example, if the primary tunnel runs OSPF, type a value higher
than OSPF’s administrative distance (by default, 110).
8. Click OK. The route is now displayed in the Network > Routing > Static Routes
window.
9. Click Save.
Move on the next task: “Create an IKE Policy for a GRE over IPsec VPN” on
page 7-222.
Configure RIP on a GRE Tunnel Interface
This section includes the most basic steps for configuring RIP on a GRE tunnel
interface. Often you must complete more steps such as redistributing con-
nected routes. For complete instructions for RIP configurations, see
Chapter 9: “Routing.”
1. Click Network > Routing and click the RIP tab.
Figure 7-180. Network > Routing > RIP Window
2. Select the Enable RIP check box.
3. Click Apply My Changes.