TMS zl Management and Configuration Guide ST.1.1.100430

7-276
Virtual Private Networks
Configure a GRE over IPsec VPN with Manual Keying
Figure 7-240. Enable RIP on Interface Window
5. For Interface, select the GRE tunnel interface, which is listed by the name
that you assigned to it.
6. For Version, select the version used by the remote tunnel gateway.
The TMS zl Module does not support RIP compatibility mode, so an
interface listening for v2 updates will reject v1 updates. Therefore, you
must select the version to match the remote gateway device or select both
versions.
7. For Metric, type the metric added for routes advertised on this interface.
8. If you do not want the module to transmit route advertisements on the
tunnel interface, select the Passive (Updates are received but not sent.) check
box; otherwise, clear the check box.
9. Under Authentication, select a Type from the list:
• None—No authentication is required on the tunnel subnet.
• Text—The module and the remote tunnel gateway authenticate each
other with simple password authentication.
–For Password, type the password. The password can contain up
to eight characters.