TMS zl Management and Configuration Guide ST.1.1.100430

7-278
Virtual Private Networks
Configure a GRE over IPsec VPN with Manual Keying
1. Select the Enable OSPF check box.
2. Click Apply My Changes.
3. Click Enable OSPF on an interface. The Enable OSPF on a VLAN window is
displayed.
Figure 7-242. Enable OSPF on a Interface Window
4. For Interface, select the GRE tunnel interface which is listed by the name
that you assigned to it.
5. For Area ID, type the number of the area to which you want to assign the
GRE tunnel interface.
6. For Cost, type the cost (metric) of this route.
7. For Hello Interval, type the hello interval for the tunnel interface.
8. For Priority, type the priority of the TMS zl Module in DR election.