TMS zl Management and Configuration Guide ST.1.2.100916

7-498
Virtual Private Networks
Configure a Shrew Soft VPN Client for Windows
Configure a Shrew Soft VPN Client for
Windows
This section describes how to configure a Shrew Soft VPN Client for Windows
to connect to the TMS zl Module.
On the TMS zl Module, you must configure a client-to-site VPN as described
in “Configure an IPsec Client-to-Site VPN” on page 7-27. See “TMS zl Module
Settings for a Client-to-Site VPN with Shrew Soft VPN Clients” on page 7-511
for a table that shows all necessary settings.
Complete the following steps:
1. Launch the Shrew Soft VPN Access Manager.
Figure 7-443. Shrew Soft VPN Client for Windows > Access Manager
2. Click Add.
3. Click the General tab.