TMS zl Management and Configuration Guide ST.1.2.100916

8-24
High Availability
Updating Cluster Software
3. Enter the participant’s global configuration.
hostswitch(tms-module-E)# configure terminal
4. Disable high-availability on the participant.
hostswitch(tms-module-E:config)# no
high-availability delete-cluster-data
Success: The HA/Cluster has been deleted successfully.
Please save the current configuration and reboot.
hostswitch(tms-module-E:config)# boot
5. Save the current configuration and reboot the module.
When asked if you would like to reboot the module and if you want to save
the current configuration, type
[y].
For example:
hostswitch(services-module-C:PR)# boot
Device will be rebooted, do you want to continue
[y/n]? y
Do you want to save the current configuration
[y/n]? y
Saving running config...
Performing user initiated reboot.
Update the Master’s Software
In this section, you will update the software on the master. All steps should
be performed on the master’s Web browser interface.
1. Click System > Maintenance > Update Software tab.
2. Follow the instructions in “Update Software with the Web Browser Inter-
face” in Chapter 2: “Initial Setup in Routing Mode“ to download and install
the new software image.
Syntax: configure terminal
Enters the configuration context for the module.
Syntax: no high-availability delete-cluster-data
Disables high-availability on the module.
Syntax: boot
Reboots the module