TMS zl Management and Configuration Guide ST.1.2.100916

9-43
Routing
OSPF
Enable OSPF on an Interface
You must enable OSPF on each TMS VLAN or GRE tunnel that you want to
participate in sending and receiving OSPF messages. When you enable OSPF
on a TMS zl Module interface, you will also define the interface’s area and
other settings.
You can place more than one interface in the same OSPF area, and you can
configure multiple OSPF areas.
To place a enable OSPF on an interface and add it to an area, complete the
following steps:
1. Click Network > Routing and click the OSPF tab.
Figure 9-13. Network > Routing > OSPF Window
2. Click Enable OSPF on an interface. The Enable OSPF on a VLAN window is
displayed.