TMS zl Management and Configuration Guide ST.1.2.100916

9-59
Routing
Multicast
Configuring Multicast Routing
To configure the TMS zl Module to receive multicasts, you complete these
steps:
1. Enable IP multicast routing.
2. Configure IP multicast routing on each interface that uses multicast
traffic.
By default, multicast routing is disabled. To enable it, complete the following
steps:
1. Click Network > Routing and click the Multicast tab.
Figure 9-24. Network > Routing > Multicast Window
2. Under Multicast Settings, select the Enable Multicast Routing check box.
3. Click Apply my changes.
4. Click Enable Multicast on Interface. The Enable Multicast on Interface win-
dow is displayed.