TMS zl Management and Configuration Guide ST.1.2.100916

10-13
Troubleshooting
Basic Troubleshooting Tools
Table 10-4. capture Extended Options
For example, you might enter:
hostswitch(tms-module-C)# capture terminal vlan 1 ip udp
Extended Command Option Purpose
sip <source IP address> Specifies the source IP address of the packets to be captured
dip <destination IP address> Specifies the destination IP address of the packets to be captured
host <host ip address> Specifies the IP address to match to either source or destination address
sp <source port> Specifies the source port of the packets to be captured
dp <destination port> Specifies the destination port of the packets to be captured
ether <network protocol type> Specifies the network protocol of the Ethernet packets to be captured
•ip
•arp
•rarp
•atalk
•aarp
• decnet
•sca
•lat
• mopdl
•moprc
•iso
•stp
•ipx
• netbeui
ip <transport protocol type> Specifies the transport protocol of the packets to be captured:
•tcp
•udp
•icmp
•igmp
•eigrp
•gre
•lt2p
•pim
•ah
•esp
•vrrp
•ospf
•multicast
pktcount <count> Specifies the number of packets to be captured. The default setting is 2,000,000. HP
recommends that you specify a smaller value because capturing a large amount of
packets can affect network throughput.