TMS zl Management and Configuration Guide ST.1.2.100916

10-20
Troubleshooting
Troubleshooting Problems with the Installation and Boot Process
You will continue to see updated output for the show services command.
The following shows an example of the output you might see. The Current
status information will vary, depending on the progress of the boot
process.
Status and Counters - Services Module E Status
HP Services zl Module J9154A
Versions : A.01.06
Current status : booting
For more information, use the show commands in
services context
When the Current status is “running” as shown below, press any key to
stop the repeated execution of the show services command.
Status and Counters - Services Module C Status
HP Services zl Module J9154A
Versions : A.01.06, B.01.03
Current status : running
For more information, use the show commands in
services context
If you enter the show services command now, it should indicate that the
module is running the TMS OS. In the example given earlier, the modules in
slots C and E would both be running the TMS OS, as shown below.
hostswitch# show services
Installed Services
Slot Index Description Name
C,E 1. Services zl Module services-
module
C,E 2. Threat Management Service tms-module