TMS zl Management and Configuration Guide ST.1.2.100916

A-67
Command-Line Reference
Global Configuration Context
end
To return to the manager context, enter end. The end command moves you
back to the manager context, regardless of the context where you enter the
command.
Syntax: end
This command is available from all contexts.
erase
This command exits the current session and reboots the router with the
factory default startup-configuration. The TMS zl Module CLI notifies you that
the startup configuration will be restored to the factory default but your IPS
signatures will not be lost) and the module will be rebooted; then it asks if you
want to continue.
Syntax: erase startup-config
Note All of your signatures will be lost if you restore your module to a previous
configuration or to factory default settings.
exit
To leave a specific interface or configuration mode, enter exit. The exit
command moves you back one mode level. For example, if you were in the
HA configuration context and entered exit, you would return to the global
configuration context.
Syntax: exit
This command is available from all contexts.
gre
With this command you can configure GRE tunnels. You can:
■ Create a GRE tunnel (page A-71)
■ Configure dynamic routing for a GRE tunnel (page A-68)
■ Enable keepalives on a GRE tunnel (page A-71)
■ Disable a GRE tunnel (page A-68)
■ Re-enable a GRE tunnel (page A-68)
■ Delete a GRE tunnel (page A-68)