TMS zl Management and Configuration Guide ST.1.2.100916

A-72
Command-Line Reference
Global Configuration Context
Replace <tunnel IP address> with an IP address that does not exist on a
subnet in your system and is not part of a TMS VLAN. This address is the IP
address assigned the tunnel interface.
Replace <peer IP address> with a virtual address that is not already used
by the device on the other end of the GRE tunnel. This will be the gateway
address for routes that use the tunnel as the forwarding interface.
Replace <zone> with the firewall zone associated for the tunnel interface.
This zone will be the source zone for traffic that arrives on the tunnel and the
destination zone for traffic that is sent across the tunnel.
Replace <source IP address> with an actual IP address on the TMS zl
Module that the remote tunnel endpoint can reach.
Replace <destination IP address> with an accessible IP address on the
remote tunnel remote (different from the address configured for the peer IP
address).
hostswitch(tms-module-<slot ID>:config)# gre SiteD tunnel
172.17.1.1 172.17.100.1 zone2 10.1.4.10 10.2.3.3
high-availability
This command allows you to configure all parts of high-availability, including:
■ Cluster scheme
■ Cluster information
•Cluster ID
• Multicast address
■ Device information
• Device ID
• Device priority
■ Cluster management
• Synchronizing
Table A-22 gives the available options for the high-availability command.
Table A-22. Options for the high-availability Command
Option Result
active-standby Sets the cluster scheme to active-standby and configures
all additional parameters