TMS zl Management and Configuration Guide ST.1.2.100916

A-107
Command-Line Reference
Global Configuration Context
Replace <rule ID> with the rule ID of the firewall access policy. This rule ID is
specific to the group and type of policy.
Replace <rate limiter> and <limiting parameters> with the options displayed in
Table A-31.
To delete a rate limiting policy, enter the following command:
Syntax: no rate-limit [ group <group name>] id <rule ID>
Replace <group name> with the name of the group to which the firewall policy
applies. This parameter is optional.
Replace <rule ID> with the rule ID of the firewall access policy. This rule ID is
specific to the group and type of policy.
Table A-31. Rate Limiter Options
For example, you want to apply a rate limit to the existing unicast policy 8 for
users that do not belong to any group. To limit the number of connections
every 30 seconds to 300, enter the following command:
hostswitch(tms-module-<slot ID>)# rate-limit id 8
connection-settings 300 30
router
This command configures all of the routing protocol settings. It leads to three
contexts:
■ RIP
■ OSPF
■ PIM
Using the router command, you can configure a few OSPF and PIM options
before entering their contexts:
For OSPF, you can configure:
Rate Limiter Limiting Parameters
max-connections <absolute maximum number of connections>
connection <maximum number of connections> <time period in
seconds>
packets <maximum number of packets> <time period in seconds>
bandwidth <maximum number of kilobytes> <time period in
seconds>