TMS zl Management and Configuration Guide ST.1.2.100916

A-113
Command-Line Reference
Global Configuration Context
Replace <authentication passphrase> with the authentication protocol pass-
phrase for the user.
Type privacy and select aes or des. Replace <privacy passphrase> with the
privacy passphrase for the user. For the manager role, you must configure
privacy settings. For the operator role, you may optionally configure privacy
settings, but are not required to do so.
For example:
hostswitch(tms-module-<slot ID>:config)# snmpv3 server
nick manager auth md5 password
time
This command displays the module’s time only. You cannot configure the
module’s time as it automatically synchronizes with the switch time.
To view the module’s time, enter the following command:
Syntax: time
traceroute
This command pings an IP address and displays the hops that the packet takes
en route to the destination.
Syntax: traceroute <IP address> [extended options]
Replace <IP address> with the IP address of the final destination to which you
want to trace the route.
The module will display a route to a destination up to 255 hops away. You can
end the traceroute process at any time by pressing
Ctrl+Z.
You can set extended options for tracing a route by typing additional keywords
after the IP address. You can specify any combination of the extended options
shown in Table A-34, and you can enter the options in any order.