TMS zl Management and Configuration Guide ST.1.2.100916

A-137
Command-Line Reference
IPsec Policy Context
IPsec Policy Apply Context
This context includes commands that are specific to configuring IPsec policies
with the apply action. This context is available only when the TMS zl Module
is in routing mode.
Figure A-11. IPsec Policy Apply Context
To enter the IPsec policy apply context, enter the following:
Syntax: action apply
To verify your location in the CLI, check the prompt. In the IPsec policy apply
context, the prompt is hostswitch(tms-module-<slot
ID>:ipsec:apply)#.
From the IPsec policy apply context, you can access the commands necessary
to create an IPsec policy that is actively applied to all traffic. You can:
■ Set the traffic selector (page A-141)
■ Set the IPsec proposal (page A-140)
■ Set the key exchange method (page A-140)
■ Enable IRAS for client-to-site VPNs (page A-149)
■ Set the advanced settings for the IPsec policy (page A-138)
■ Preview the IPsec policy (page A-140)
■ Apply the IPsec Policy (page A-139)