TMS zl Management and Configuration Guide ST.1.2.100916

A-156
Command-Line Reference
IPsec Policy Context
Figure A-16. IPsec Policy Deny Context
To enter the IPsec policy deny context, enter the following:
Syntax: action deny
To verify your location in the CLI, check the prompt. In the IPsec policy deny
context, the prompt is hostswitch(tms-module-<slot
ID>:ipsec:deny)#.
To exit the IPsec policy deny context, enter the following:
Syntax: exit
If you have not set all of the necessary configurations, you will be prompted
to do so and asked whether you actually want to exit.
The sections below document the commands available in the IPsec policy
deny context. You can:
■ Set the direction (page A-157)
■ Set the traffic selector (page A-157)
■ Preview the IPsec policy (page A-158)
■ Apply the IPsec policy (page A-157)