TMS zl Management and Configuration Guide ST.1.2.100916

A-165
Command-Line Reference
L2TP User Context
To verify your location in the CLI, check the prompt. In the L2TP context, the
prompt is hostswitch(tms-module-<slot ID>:l2tp-user)#.
To exit the L2TP User context, enter the following:
Syntax: exit
If you have not applied your changes, you will be warned to do so and asked
if you want to continue.
From the L2TP user context, you can:
■ Set the configuration parameters for the L2TP tunnel (page A-167)
■ Set the user’s group and authentication protocol (page A-165)
■ Set the DNS and WINS servers (page A-166)
■ Preview the L2TP user settings (page A-166)
■ Apply the user settings (page A-165)
apply
Once you have configured the L2TP user, you must apply the settings. The
apply command verifies that all required settings are configured and then
adds or edits the user. (If the requirements are not met, the command does
not take effect, and an error message indicates which settings are missing.)
Enter the following command:
Syntax: apply
auth group
To set the user group to which the L2TP user belongs, as well as the authen-
tication protocol, enter the following command:
Syntax: auth group <group> protocol <any | ms-chap | chap | pap>
Replace <group> with the name of the user group for this user. The group
must already be configured on the TMS zl Module. (When you configure
firewall access policies that control this L2TP user’s access, you will configure
them for this user group.)
After entering this command, you will be prompted to input the user’s pass-
word. For the password, enter a case-sensitive string.