TMS zl Management and Configuration Guide ST.1.2.100916

A-176
Command-Line Reference
RIP Context
RIP Context
The RIP context provides commands for configuring global RIP settings. It is
available only when the TMS zl Module is in routing mode.
Figure A-18. RIP Context
To enable RIP and access the RIP context, enter the following command from
the global configuration context:
Syntax: router rip
To verify your location in the CLI, check the prompt. In the RIP context, the
prompt is hostswitch(tms-module-<slot ID>:rip)#.
From this context you can:
■ Set the default metric
■ Enable or disable poison reverse
■ Redistribute routes—connected, static, and OSPF
■ Restrict addresses from advertisement
To exit the RIP context, enter the following command:
Syntax: exit