TMS zl Management and Configuration Guide ST.1.2.100916

A-182

Command-Line Reference

VLAN Context

This context provides commands for configuring TMS VLAN settings. It is

available only when the TMS zl Module operates in routing mode. The VLAN

context for a specific VLAN is not available until you have assigned the VLAN

to a zone with the vlan <ID> zone command.

Figure A-20. VLAN Context

To enter the VLAN context, enter the following:

Syntax: vlan <VLAN ID>

Replace <VLAN ID> with the VLAN ID.

To verify your location in the CLI, check the prompt. In the VLAN context, the

prompt is hostswitch(tms-module-<slot ID>:vlan-<VLAN ID>)#.

From the VLAN context, you can:

■ Change the VLAN’s zone

■ Assign the VLAN IP settings

■ Activate IGMP

■ Configure routing settings—RIP, OSPF, or PIM-Sparse Mode