TMS zl Management and Configuration Guide ST.1.2.100916

A-187

Command-Line Reference

VLAN PIM Context

Figure A-21. VLAN PIM Context

To enter the VLAN PIM context, which is available only when the TMS zl

Module is in routing mode, enter the following command from the VLAN

context:

Syntax: ip pim-sparse

To verify your location in the CLI, check the prompt. In the VLAN context, the

prompt is hostswitch(tms-module-<slot ID>:vlan-<VLAN ID>-

pim-sparse)#.

From this context, you can set the TMS zl Module’s DR priority on the VLAN.

Syntax: dr-priority <priority>

Replace <priority> with the priority of the TMS zl Module during DR elec-

tions (0–4294967295).

To exit the VLAN PIM context, enter the following command:

Syntax: exit