TMS zl Management and Configuration Guide ST.1.2.100916

A-199
Command-Line Reference
Product OS Show Commands
To view the IPS web-proxy settings, enter the following command:
Syntax: show ips web-proxy
To view the IPS protocol anomaly settings, enter the following command:
Syntax: show ips protocol-anomaly
To view if the IPS engine is using full session inspection, enter the following
command:
Syntax: show ips full-inspection
To view the current IPS inspection-depth setting, enter the following com-
mand:
Syntax: show ips inspection-depth
show ipsec
This command shows your IPsec settings.
To view all of your global IPsec settings, enter the following command:
Syntax: show ipsec
The global settings that are displayed are:
■ whether IPsec is enabled globally
■ whether sending ICMP error messages is enabled
■ whether handling ICMP error messages is enabled
■ the maximum SAs per policy
■ whether auto SA revalidation is enabled
■ the minimum packet size for IP compression
You can also add additional parameters to the show ipsec command to view
additional information about your IPsec settings, such as:
■ IKEv1 policies
Enter the following command:
Syntax: show ikev1 [policy name]
To view detailed information about only one policy, replace [policy
name] with the name of a specific policy. Otherwise, all IKEv1 policies
are displayed (with less information about each).