TMS zl Management and Configuration Guide ST.1.2.100916

2-56

Initial Setup in Routing Mode

Modify Management Settings

To access the Web browser interface, you configured a set of management

settings. You enabled management access on a zone, added a VLAN to that

zone, and configured a static IP address for the VLAN. The TMS zl Module

allows you to manage the module from as many zones as you want, so you can

specify additional zones as management-access zones.

To view and change the module’s management access on the zones, complete

the following steps.

1. Click Network > Zones and click the Management Access tab.

Figure 2-26. Network > Zones > Management Access Window

2. Select the check boxes for the zones from which you want to permit

management traffic to the module. Conversely, clear the check boxes for

the zones where you want to deny management access.

3. Click Apply My Changes.

The module now automatically creates all of the access policies necessary

to permit management traffic from the zones that you selected, as shown

in Table 2-11 and Table 2-12.