TMS zl Management and Configuration Guide ST.1.2.100916

2-86

Initial Setup in Routing Mode

Configure SNMP Settings

The TMS zl Module allows remote management through SNMPv1/v2c or

SNMPv3. For example, you can configure SNMP so that the module can be

managed by PCM+. If you are going to allow remote management through

SNMP, make sure that you configure the parameters on the TMS zl Module to

match those configured on the SNMP server. (You can also configure the TMS

zl Module to send SNMP traps. See “Configure SNMP Traps” on page 2-83.)

Configure SNMPv1/v2c Settings

Figure 2-50. System > Settings > SNMP Window

To configure SNMPv1/v2c settings, complete the following steps:

1. Click System > Settings and then click the SNMP tab.

2. Select Enable SNMPv1/v2.

Two default communities are enabled:

• Public:

– Role = Manager

– Write Access = Restricted