TMS zl Management and Configuration Guide ST.1.2.100916

2-94

Initial Setup in Routing Mode

System Maintenance

This section teaches you how to complete these system maintenance tasks on

the TMS zl Module:

■ Save the current startup-config to an external drive.

See “Back Up the Startup-Config” on page 2-94.

■ Restore the startup-config to a previously saved configuration.

See “Restore to a Previously Saved Configuration” on page 2-95.

■ Erase the startup-config and return to factory default settings (retaining

any existing IDS/IPS signatures).

See “Erase the Startup-Config and Return to Defaults” on page 2-96.

■ Return to factory default settings including erasing the IDS/IPS signatures.

See “Restore to Factory Default Settings (Including IDS/IPS Signatures)”

on page 2-98.

■ Update the software.

See “Update the Module Software” on page 2-100.

Note Remember the definitions of running-config and startup-config:

■ You click Apply My Changes and similar buttons to save changes to the

running-config.

■ You click Save, located in the top-right corner of the Web interface, to save

the running-config to the startup-config.

Back Up the Startup-Config

The TMS zl Module allows you to save your current startup-config to an

external drive. It is recommended that you frequently save the startup-config

to a hard drive so that you can restore it to the TMS zl Module if the running-

config becomes corrupted or unusable for any reason.

To back up the current startup-config:

1. Click System > Maintenance and click the Back Up/Restore tab.