TMS zl Management and Configuration Guide ST.1.2.100916

2-97
Initial Setup in Routing Mode
System Maintenance
Erase the Startup Configuration from the CLI Product OS
You can erase the startup configuration from the Product OS context by
following these steps:
1. Access the TMS zl Module Product OS in one of the following two ways:
• Through the host switch CLI:
i. Access the host switch CLI and enter the manager context.
ii. Enter the Product OS context for the TMS zl Module:
• Through SSH:
i. Open an SSH client on a management workstation in a manage-
ment-access zone.
ii. Establish a connection to a TMS zl Module IP address.
iii. If prompted, accept the module’s key.
iv. When prompted for a username, enter manager.
If you are using a RADIUS server to authenticate management
users, you can alternatively enter the username for a user with
manager (Administrative) access.
v. When prompted for a password, enter the manager user’s pass-
word.
2. Erase the startup-config without deleting IDS/IPS signatures:
3. When prompted, press
[y] to confirm. The module then reboots with the
factory default settings but the current IDS/IPS signatures.
Syntax: services <slot ID> < <product index> | name <product name> >
Moves you to an OS context on the module.
Replace <slot ID> with the letter for the chassis slot in
which the module is installed.
Replace <product index> with the product index assigned
tot he TMS zl Module. See “Understanding Index Num-
bers” on page 2-18.
Replace <product name> with tms-module. The TMS zl Mod-
ule’s Product OS context is always assigned the product
name tms-module.
Syntax: erase startup-config
Deletes all settings but does not delete the IDS/IPS signatures.