TMS zl Management and Configuration Guide ST.1.2.100916

3-11
Initial Setup in Monitor Mode
Initial Setup
Understanding Index Numbers
The host switch assigns index numbers to all TMS zl Module and HP ONE
Services zl Module products according to these rules:
■ The host switch always assigns index number 1 to the Services OS that
runs on ONE Services zl Modules and TMS zl Modules.
■ The host switch assigns index numbers to other products based on the
order in which the products boot. The first to boot is assigned index
number 2 and so forth.
■ The index numbers assigned to products can change. For example, if a
module is rebooted, the index number for the product or products that
run on that module might change. Similarly, when a switch is rebooted or
powered off and on, the index numbers can change.
■ A product is assigned only one index number even if more than one
module runs that product.
You can always check the product index numbers by entering the show
services command. Table 3-2 shows an example output for this command. In
this example, only TMS zl Modules are installed in the host switch, so TMS
will always boot first, and the host switch assigns index number 2 to the TMS
zl Module.
Table 3-2. CLI Display of Services Example 1
Table 3-3 shows another example of the output for the show services com-
mand. In this example, two TMS zl Modules and a ONE Services zl Module
running Data Center Connection Manager (DCM) are installed on the switch.
The module running DCM booted first so it was assigned index number 2. The
TMS zl Modules booted later, so they were assigned index number 3.
Table 3-3. CLI Display of Services Example 2
Slot Index Description Name
C,E 1. Services zl Module services-module
C,E 2. Threat Management Services zl Module tms-module
Slot Index Description Name
C,D, E 1. Services zl Module services-module
D 2. Data Center Connection Manager dcm
C,E 3. Threat Management Services zl Module tms-module