TMS zl Management and Configuration Guide ST.1.2.100916

3-15

Initial Setup in Monitor Mode

Initial Setup

To obtain the activation hardware ID, complete the following steps:

1. Access the host switch’s CLI.

2. From the host switch’s manager-level context, enter the TMS zl Module’s

Services OS context:

You are now in the Services OS context, and you should see a prompt that

is similar to the following:

hostswitch(services-module-C:HD)#

The “HD” in the prompt indicates that the TMS zl Module is booted to the

Services OS.

3. Display the activation hardware ID by entering the following command:

4. Record the activation hardware ID. (You may want to copy the activation

hardware ID to a text file.) You will use this hardware ID to register the

TMS zl Module so that you can receive a product license key.

Once you have obtained the product registration ID and the activation hard-

ware ID, you can complete the TMS zl Module registration process on the My

Networking portal.

1. Open a Web browser and enter

http://hp.com/networking/

mynetworking

in the address bar.

Syntax: services <slot ID> 1

Moves you to the Services OS context.

Replace <slot ID> with the letter of the chassis slot in

which the module is installed.

Syntax: licenses hardware-id activation

Displays the product activation hardware ID.