TMS zl Management and Configuration Guide ST.1.2.100916

3-58
Initial Setup in Monitor Mode
Configuring Event Logging
4. For Address, type the IP address or FQDN of the syslog server.
5. For Port, type the port number of the syslog server. The well-known port
for syslog is 514.
6. From the Facility list, select the facility from which the events will be sent.
7. Click OK.
8. Click Save.
Use the Edit and Delete icons in the Tools column to alter or remove a syslog
server.
Configure SNMP Traps
SNMP traps are unsolicited messages that managed devices send to alert you
about specific events. For example, you can configure the TMS zl Module to
send SNMP traps to HP ProCurve Manager Plus (PCM+) and its plug-in
Network Immunity Manager, (NIM).
The TMS zl Module supports the standard MIB-II, the IF-MIB, and a proprie-
tary MIB that is specific to the operation of the TMS zl Module.
Note If you configure SNMP traps from the PCM+ interface instead of from the
TMS zl Module interface, the module will send only MIB-II and IF-MIB traps
to the PCM+ server, not proprietary MIB traps. The proprietary MIB can be
found in the help files on the module.
To configure SNMP traps, click System > Logging and then click the SNMP
Traps tab.
Figure 3-35. System > Logging > SNMP Traps Window