TMS zl Management and Configuration Guide ST.1.2.100916

3-60
Initial Setup in Monitor Mode
Configuring Event Logging
Figure 3-37. Add SNMPv3 Destination Window
2. For Server Address, type the IP address or FQDN of an SNMPv3 server.
For example, if you are using PCM+/NIM, you would enter the IP address
or FQDN of the server running PCM+/NIM.
3. For Username, type a username for the SNMPv3 account that will be used
with this trap destination.
The username must match a username in an account on the SNMPv3
server. The remaining settings must also match the settings in that
account.
4. For Auth Passphrase, type the authentication passphrase for this user.
The passphrase must be at least 8 characters (special or alphanumeric).
5. For Auth Protocol, select the authentication protocol configured for this
user on the SNMPv3 server: MD5 or SHA-1.
6. For Privacy Passphrase, type the privacy (encryption) passphrase for this
user.
The passphrase must be at least 8 characters (special or alphanumeric).
7. For Privacy Protocol, select the privacy protocol for this user account on
the server: DES or AES.
8. Click OK.
9. Click Save.
If you want to add more SNMP v3 trap receivers, repeat these steps. Use the
Edit and Delete icons in the Tools column to modify or remove a trap receiver.