TMS zl Management and Configuration Guide ST.1.2.100916

3-61
Initial Setup in Monitor Mode
SNMP Settings
SNMP Settings
The TMS zl Module supports SNMPv1/2 and v3, allowing you to manage it
through an SNMP management console (such as PCM+/NIM). If you are going
to allow remote management through SNMP, make sure that you configure
the SNMP settings on the TMS zl Module to match those configured on the
SNMP management console. (You can also configure the TMS zl Module to
send SNMP traps. See “Configure SNMP Traps” on page 3-58.)
Configure SNMPv1/v2c Settings
To configure SNMPv1/v2 settings, complete the following steps:
1. Select System > Settings and click the SNMP tab.
Figure 3-38. System > Settings > SNMP Window
2. Select Enable SNMPv1/v2.
Two default communities are enabled:
• Public:
– Role = Manager
– Write Access = Restricted