TMS zl Management and Configuration Guide ST.1.2.100916

3-63
Initial Setup in Monitor Mode
SNMP Settings
7. Click OK.
8. Click Save.
If you want to add more SNMPv1/v2 communities, repeat these steps.
Note If you add new communities rather than edit the default communities, the
default communities will continue to allow access unless you delete them. To
delete a community, click the Delete (X) icon in the Tools column for that
community.
Configure SNMPv3 Settings
To configure SNMPv3 settings, complete the following steps:
1. Select System > Settings and click the SNMP tab.
2. Select Enable SNMPv3 and click Add another user. The Add SNMPv3 User
window is displayed.
Figure 3-41. Add SNMPv3 User Window
3. For User Name, type the SNMPv3 username for the account.
The username must match a username in an account on the SNMPv3
server. The remaining settings must also match the settings in that
account.