TMS zl Management and Configuration Guide ST.1.2.100916

3-65
Initial Setup in Monitor Mode
SNMP Settings
To manage your module through PCM+/NIM, you must configure SNMPv1/2c
with the PCM+ server’s community names or SNMPv3 with the user settings
specified on PCM+. (See “SNMP Settings” on page 3-61.) For more information
about managing the TMS zl Module through PCM+/NIM, see the HP ProCurve
Manager Network Administrator’s Guide, version 3.10 or later.
Note In addition to managing the TMS zl Module with PCM+/NIM, you can integrate
the module’s IDS functions with the threat management solution controlled
by NIM. See “Managing the TMS zl Module with HP Network Immunity
Manager” on page 6-38 of Chapter 6: “Intrusion Detection and Prevention.”