TMS zl Management and Configuration Guide ST.1.2.100916

3-66

Initial Setup in Monitor Mode

Ping Utility

You might want to check the TMS zl Module’s connectivity with devices such

as SNMP trap servers, PCM+/NIM, or a syslog server.

To ping an IP address or hostname, complete the following steps:

1. Click System > Utilities > Ping.

2. For Hostname/IP Address, type the hostname or IP address of the device

you are trying to reach.

3. For Repetitions, select the number of ping messages you want to the

module to send.

You can configure a maximum of 10 repetitions from the Web browser

interface. If you want a higher number of repetitions, you can enter the

ping command from the CLI, which supports a maximum of 10,000

repetitions.

4. For Data Size, type the number of bytes you want to be included in each

ping packet sent (0–65471).