TMS zl Management and Configuration Guide ST.1.2.100916

4-11
Firewall
Named Objects
Note You cannot combine address types in a one address object. For example, you
cannot combine address ranges with network addresses. To create a named
object with more than one address type, create an address group (see “Address
Groups” on page 4-13).
For IP, range, and network address objects there are two entry types:
■ Single-entry—can be used in address groups, firewall access policies,
NAT policies, port triggers, and IPsec policy traffic selectors
■ Multiple-entry—can be used in address groups and firewall access
policies
To create an address object, follow these steps:
1. Click one of the following:
• Firewall > Access Policies and click the Addresses tab
• Firewall > NAT Policies and click the Addresses tab
• Firewall > Port Triggers and click the Addresses tab
Figure 4-2. Firewall > Access Policies > Addresses Window
2. Click Add an Address.