TMS zl Management and Configuration Guide ST.1.2.100916

4-56
Firewall
User Authentication
Figure 4-33. System > Settings > General Window
2. If you want to use HTTP or HTTPS ports other than the well-known ports,
configure the settings under Web Sessions. These port numbers will apply
to both the authenticating users and management users. You also might
need to configure a port map for the new HTTP port. See “Port Mapping”
on page 4-85.)
a. For HTTP Port, type the new port for HTTP authentication traffic.
b. For HTTPS Port, type the new port for HTTPS authentication traffic.
3. For Terminate sessions after, set the inactivity timeout for authenticated
sessions in minutes.
4. For Login Banner Page Text, type the text that you want to be displayed on
the login page.
5. Click Apply My Changes.
6. Click Save.
Configure the Access Policy to Permit Log in Traffic
To configure the rate-limiting access policy that allows HTTPS traffic from the
zone from which you want require authentication, complete the following
steps:
1. Click Firewall > Access Policies > Unicast.