TMS zl Management and Configuration Guide ST.1.2.100916

5-26
Network Address Translation
NAT Examples
Figure 5-11. Source NAT—Network Merger Example
Follow these steps to configure the first module (illustrated in the lower
segment of the figure):
1. Create a NAT policy to translate source addresses on traffic from Zone1
to the shared data center (Zone 3).
a. Click Firewall > NAT Policies > Policies.
b. Click Add Policy.
c. For Translate, select Source.
d. For From Zone, select ZONE1.
e. For To Zone, select ZONE3.
f. For Service, accept the default: Any Service.
g. For Source, click Options and select Enter custom IP, IP/mask or IP-Range.
Then type 192.168.8.0/21.
h. For Destination, click Options and select Enter custom IP, IP/mask or IP-
Range. Then type 10.1.1.0/24.