TMS zl Management and Configuration Guide ST.1.2.100916

5-29
Network Address Translation
NAT Examples
Follow these steps to configure the second module (illustrated at the top of
the figure):
1. Create a NAT policy to translate source addresses on traffic from Zone1
to the shared data center (Zone 3).
a. Click Firewall > NAT Policies > Policies.
b. Click Add Policy
c. For Translate, select Source.
d. For From Zone, select ZONE1.
e. For To Zone, select ZONE3.
f. For Service, accept the default: Any Service.
g. For Source, click Options and select Enter custom IP, IP/mask or IP-Range.
Then type 192.168.8.0/21.
h. For Destination, click Options and select Enter custom IP, IP/mask or IP-
Range. Then type 10.1.1.0/24.
i. Select Use IP of routed VLAN interface.
The module will translate all source Address(es) to its own IP address
on the VLAN interface to which the NATed traffic is routed—in this
example, 10.1.1.2.