TMS zl Management and Configuration Guide ST.1.2.100916

5-37
Network Address Translation
NAT Examples
4. Create a firewall access policy to permit the NAT traffic.
a. Select Firewall > Access Policies > Unicast.
b. Click Add Policy.
c. For Action, select Permit Traffic.
d. For From, select INTERNAL.
e. For To, select ZONE5.
f. For Service, accept the default: Any Service.
g. For Source, select VLAN10.
h. For Destination, select VLAN2.
i. Select the Enable this Policy check box to enable the access policy.
j. Select the Enable IPS for this Policy check box to enable IPS to check
packets on this policy.
k. Select the Enable logging on this Policy check box to log access policy
activities.
Note It is not recommended that you enable logging permanently because
policy logging is processor intensive. Use policy logging for troubleshoot-
ing and testing only.
Figure 5-21. Add Policy Window