TMS zl Management and Configuration Guide ST.1.2.100916

6-34
Intrusion Detection and Prevention
Configure IDS/IPS
Figure 6-11. Filters for Viewing Signatures Based on the Protection They Provide
• Threat Level—Select Any to view all signatures, no matter what threat
level they have, or select one of the following to view signatures with
a specific threat level: Critical, Severe, Minor, Warning, or Information.
For example, you might set the Status filter to All, the Protection filter to
Servers, and the Threat Level filter to Critical. You would then view all
signatures that meet these criteria:
• Detect attacks that target servers
• Have a threat level of Critical
Enable or Disable Signatures
By default, all the signatures are enabled. To disable a particular signature,
clear its Enable check box.
You can also click Enable All or Disable All for each signature family. However,
you cannot disable signatures in the protocol anomaly family.
The signature detection is applied to all traffic, regardless of zone.