TMS zl Management and Configuration Guide ST.1.2.100916

6-35
Intrusion Detection and Prevention
Configure IDS/IPS
Figure 6-12. Intrusion Prevention > Signatures > View Window
Note If you disable a signature, the IDS/IPS will no longer check packets against
that signature, leaving your network vulnerable to known attacks.
Configure IPS Actions (Routing Mode Only)
Each signature or protocol anomaly is pre-assigned one of five threat levels:
■ Critical
■ Severe
■ Minor
■ Warning
■ Informational
You can configure the TMS zl Module to take one of three actions on traffic
that matches a specific IPS threat level.
Note These actions apply to threats detected by signatures. The action taken in
response to protocol anomalies is set at the factory and cannot be changed.